Blayne Steed King wrote this.
To make the above snow piece, you will need the following scener pieces:
- Cutting knife
- Pink foam
- Protective Seal Spray. Baking Soda
- ROSS All Purpose dry clear glue
- Smelly primer
- Space wolves grey
- Regal blue
- Super spray 77 (will not melt foam)
Step 1
Using the cutting knife I carved the two pieces of pink foam to fit together on one side.
Step 2
After the pink foam was carved I then applyed them together using ROSS All Purpose dry clear glue.
Step 3
When the glue had dried I used a paint brush to uncoat the entire piece using regal blue.
Step 4
For the areas that I wanted to look higher in altitude I used smelly primer overlayers of space wolves grey.
Step 5
To add the snow texture I wanted on the piece I used a foam sprey adhesive over the areas I wanted to be flocked with a snow surface.
Step 6
Adding some baking soda over the sprayed areas of the pink foam I flocked it on with slightly heavy coats.
Step 7
Make sure you have covered the entire pink foam piece with layers of paint or the spray will melt through the pink foam. Now that that is done use a protective spray sealer to have the baking soda stay put. I would do this project outside or in a spray booth. I always try to wear a dust mask to protect myself from the particulants.